Keep your water heater running efficiently and reliably with this simple maintenance routine.
Water Heater Maintenance Gipton. Hot water heaters work hard for you personally, providing warm baths, clean clothes, and sparkling pots and pans.
So show your water heater some love by adhering to a routine maintenance schedule that’ll keep it running for the 15-year expected lifetime, and perhaps beyond.
Here’s What You Need To Do with Hot Water Heater Maintenance:
Adjust the thermostat to 120 degrees.You’ll save up to 5% in energy costs for every single 10 degrees you lower the temperature, plus you’ll reduce the danger of scalding.
Always maintain 2 feet of clearance around the applying unless the manual specifically states otherwise.
Drain about a quarter of the tank several times per year to get rid of sediment and debris. Switch off the cold water supply, attach a garden hose to the drain valve, then run into a bucket before water is clear. If the water remains cloudy, briefly open the water supply valve to stir up remaining sediment, and drain the tank again. And also this makes the machine operate more quietly.
Annually test the temperature-pressure relief valve by quickly discharging it several times. Following the testing, keep an eye out for small leaks from the valve.
Examine the sacrificial anode rod every four years by loosening the hex head screw and removing it. Replace the rod if:
- More than 6 inches of the core steel wire is exposed.
- The rod is less than 1/2 inch thick.
- The rod is coated with calcium.
- You can buy a 13-inch zinc-aluminum anode rod for around $16.
Insulate older units with a fiberglass jacket to improve efficiency, being careful to prevent experience of the flue (newer units already are insulated — check your owner’s manual to produce sure). Also, insulate the hot and cold water pipes.
When leaving town, adjust the thermostat on gas heaters to “vacation” setting, which maintains the pilot light without heating the water. Water Heater Maintenance Near My Location Gipton. Source